The two lower feet have the holes at the 9 o'clock on the left, the 3 o'clock on the right, though not as close to the edge as the upper holes. With the label readable, the two upper feet have their screw holes at the 6 o'clock position. To open the case, carefully remove the four round rubbers on the back side of EA8300. Stiff, plastic spatula for prying apart the case top from bottom (slightly smaller than thickness of groove is good) Note that the boot loader, by default, erases for flashing an 88 MiB (0x05800000) image size. Raw NAND flash memory chip (Winbond W29N02GV) 256 MiB, SLC, erase size: 128 KiB, page size: 2048, OOB size: 64 Macronix MX30LF2G18AC-TI or Winbond W29N02GVĢ56 MiB, SLC, erase size: 128 KiB, page size: 2048, OOB size: 64Ĩ67 Mbps (802.11ac 80 MHz ch.) (only ch. If you were updating using WiFi, you will need to connect using an Ethernet cable, as the image brings WiFi disabled by default. OpenWrt should be running at this point with default “ LAN” address, 192.168.1.1, with no password. This may occur even if you have LuCI installed, as the URL is not one that LuCI recognizes. The firmware will upload, the router will reboot, and likely when the browser refreshes, will tell you that the router was not found. ![]() Once you have confirmed you have selected the proper OpenWrt factory.bin file, click “Start” On the “Connectivity” screen, in the “Manual” section, choose the OpenWrt factory.bin file using the file-picker window. On the “Smart Wi-Fi Tools” screen, select “Connectivity” At this time (early 2019), the default is admin On the “Sign In” screen, enter the password, then click “Sign In”. On the “Internet connection is down” screen, after confirming that the “Login” button is to “log in to your router without Internet access”, click the “Login” button. Power up the router and wait for it to boot, The white, LINKSYS light will be on solid when the router is booted and ready.ĭo not hit “Next” but instead proceed to “Manual configuration” These screenshots and directions for OEM v1.1.3, as shipped in early 2019. If you get totally lost and can't get there, a reset to factory defaults, as described just above, can be helpful. The Linksys GUI makes it challenging to navigate past their “helpful” cloud service and to find how to upload firmware.
0 Comments
Leave a Reply. |